MXstore graphics kits installation guideUpdated 2 months ago

Just received your new MXstore Graphics Kit? Follow the steps below to get the best fit and longest life from your graphics.

Before You Start

• Check that each graphic matches the correct plastic before removing the backing paper.
• Lay the graphics over your plastics first to confirm the shape and fit.

Remove Old Graphics

• Warm the existing graphics with a hairdryer or heat gun on a low to medium setting.
• Slowly peel them away at a 90° angle.
• Remove any leftover adhesive using isopropyl alcohol or mineral turpentine.

Prepare the Surface

For the best results, clean the plastics thoroughly using:

• Isopropyl alcohol
• Vinyl prep
• Brake or contact cleaner

Make sure the surface is completely clean, dry, and free of dirt, oil, dust, and adhesive residue before applying your new graphics.

Apply Your Graphics

• Position each graphic carefully before pressing it down.
• If needed, use a small amount of heat from a hairdryer or heat gun to help the graphic conform to curves.
• Avoid overheating the material.

After Installation

• Check your graphics the following day for any edges that may have lifted.
• If needed, apply gentle heat and firmly press the edges back down.
• We recommend waiting 72 hours before riding to allow the adhesive to fully bond.

Important Information

Incorrect installation is not covered under warranty. If you notice any issues with the quality of your graphics kit, please contact us before fitting or riding.

Keep in mind that dirt bikes are built to be ridden, so normal wear and tear to your graphics over time is expected.